[#ZKSwap V2 Testnet Feedback#]

Hello, I participated in the first testnet and now trying V2.

I tested V2 both from a hand held device and PC just to get a greater experience. I found the UI and UX to be reasonably easy to use and aesthetically pleasing. I did however have a couple of minor issues that i thought could be addressed to improve user experience:

Trouble swapping between wallet addresses

  • I had trouble swapping between different wallet addresses via Metamask. When trying to go between wallets I found that the disconnect button did not actually seem to respond and required me to manually disconnect my wallet via metamask then refresh the ZKswap page. This then allowed me to connect the desired wallet. It wasn’t a big deal but it was clunky and time consuming.
    Error message popup shows up and the disappears too quickly.
  • Error messages should show at least 3 - 5 seconds or have a ‘read/ do not show me this again’ prompt
  • Error messages should show below the SWAP button in red text instead of popup if possible

My user id @ayush
Wallet address:- 0x7984e56E37D7A4E534A7ca0936fc9b0a04b1dd1D